The profile C9R is a further development of the profile C5R. Combined with the wear-resistant elastomer part, this profile was additionally provided with a back-ring. Thereby the pressure strength got increased and gap extrusion prevented, which with rotation, do to eccentricity often happens. This one sided agent seal, herefor is able to compensate higher pressure peaks.
- unempfindliche gegen Spaltextrusion
- easy to install
- also available in EPDM and FKM
|working pressure:||≤ 4,0 MPa (40bar)|
|operation temperature:||- 30 °C to + 100 °C (NBR)|
|- 25 °C to + 200 °C (FKM)|
|sliding speed:||≤ 0,2 m/s, recommendation: PxV ≤ 0,3 1)|
Often used with mobile- and machine tool-hydraulic, with low pressure swivel screw-fittings, as well as endseals, with rotary feed through, of construction equipment.
Standard compound for the rubber sealing is a NBR-based elastomer (N3764), with a hardness of approx. 90 Shore A. The back-up ring is made of a polyacetal-based material (W5001).
To ensure a perfect function, the groove width must be larger than the seal width (look at chart). The C9R is easy to install in closed grooves. While installing, first place the rubber part and later the back-ring. So the seal won´t be damaged, don´t pull it over sharp edges. Edges within the seal housing have to be provided with radii (look at mounting layout).
In certain cases (high temperature, speed, specific resistance to pressure a.s.o.) please contact with our application technology.
1) product from pressure (MPa) and sliding speed (m/s) should not exceed 0,3
|90||110||10||11||C9R 0091 SN656|
|105||125||10||11||C9R 0105 SN656|
|115||135||10||11||C9R 0115 SN656|
|130||150||10||11||C9R 0131 SN656|
|130||150||10||11||C9R 0130 SN656|
|140||160||10||11||C9R 0140 SN656|
|160||180||10||11||C9R 0160 SN656|
|170||190||10||11||C9R 0170 SN656|
|200||220||10||11||C9R 0200 SN656|
Further sizes on request.